94.5-97 7.3L CNC Fabrication High Pressure Oil Pump Line Kit w/ Crossover

Description

Replace your high-mileage (and expensive) OEM High Pressure Oil Pump lines with a CNC Fabrication upgrade!

94-97 OBS Ford Powerstroke 7.3L Replacement High Pressure Oil Pump Line Kit with Crossover

The HPx line connects the two heads to help balance the high pressure oil system in each head.  It does not create more horsepower, but the majority of owners see a slight to significant decrease in engine idle noise.

This is due to the Helmholtz resonance that is created from the injectors firing so quickly, and the hpop cannot react quick enough to balance/absorb on its own from back pressure spikes within the system.

So when the tiny spikes happen, the hpx line sends the pressure back and forth through the heads instead of hammering on the pump itself.

Details:

• 94-97 OBS Ford Powerstroke 7.3L
• Replacement High Pressure Oil Pump Lines
• Advanced HPOP lines with DuPont Teflon lining.
• Burst pressure rating of 16,000psi and working temperature rating of 400 F
• Nominal working pressure is 5000psi at 72 F and 3000psi at 400 F
• Kit comes with Genuine Brennan fittings
• High quality Viton o-rings
• Made in the USA

INSTALLATION:  

Disconnect the battery grounds before installation to avoid accidentally arc’ing the line on the glow plug relay or the alternator charging lug. Use pictures from the product webpage for routing example. The fittings are marked with numbers to label install location (see below for reference). After installation, be sure there is no other lines/wires that are touching the lines that could potentially rub through and damage either the HPOP line or the other line that may be touching it.  Use a small section of wire loom protector or a larger piece or rubber hose to wrap around the contact point.  Many will remove or bend the engine eyelet on the driver side as a precaution, but it is not necessary.  Sealant is not necessary, but IF you choose to use any, use Loctite 680 or Permatex 64000 retaining compound (green) only on the fittings installed in the HPOP.  If you are unsure of installing yourself, seek out a competent and qualified technician to install the lines.

*REMOVE THE SPRING CHECKS IN THE PUMP UNDER THE STOCK FITTINGS, DO NOT RE-INSTALL*

**94.5-97 OBS driver side line fitting gets moved forward one port on the head to match 98.5-03 Superduty**

HOSE IDENTIFICATION: 98.5-03 Superduty 2 LINE – BOTH SIDES ARE SAME LENGTH 94.5-97 OBS 2 LINE – PASSENGER IS LONGER OF THE 2 

**FOR ANY 3 LINE KIT THE SHORTEST LINE IS THE CROSSOVER HOSE**

FITTING MARKINGS: 1– FRONT PUMP PORT 2– REAR PUMP PORT 3– DRIVER HEAD 4– OBS PASSENGER HEAD 5– SD PASSENGER HEAD AND CROSSOVER 

Pump Fittings: 28FT/LBS • Head Fittings: 23FT/LBS • Hose Ends: 21FT/LBS